Story
Small
Image
view of an industrial site and a blue sky
Disable image alteration
Off
HCl and mercury control with a low-cost DSI solution
Off
HCl and mercury control with a low-cost DSI solution
One column
The challenge

Industrial boilers in the U.S. face increasing compliance challenges related to changes in National Emission Standards for Hazardous Air Pollutants (NESHAP) regulations. These require many plants to add equipment to control mercury, hydrogen chloride (HCl), and particulate matter. Dry sorbent injection (DSI) of calcium-based products is a low-capital-cost approach to meeting these new limits for HCl and other acid gases.

When mercury control is also a concern, a blended sorbent containing both an enhanced hydrated lime and activated carbon (Sorbacal® Micro) can be an economical approach, as it eliminates the need for two separate injection systems. A major US chemical manufacturer located in West Virginia, asked Lhoist to provide such a product.

Open cta in a new tab
Off
Background Grey
Off
One column
The Lhoist solution

Our flue gas treatment team worked with the customer to conduct trials comparing separate injections of Sorbacal® SP and activated carbon to a single injection of a Sorbacal® Micro blend. Sorbacal® SP is an enhanced hydrated lime designed for emission control applications, while the Sorbacal® Micro blend is a customized blend of both Sorbacal® SP and high-quality activated carbon. 

A portable DSI system with dual injection capability was used on site to separately inject the hydrated lime and activated carbon. It was then used to inject the blended sorbent into the duct just prior to an existing baghouse, where the temperature was 380-390°F (190-200°C). A Fourier transform infrared (FTIR) system provided real-time stack acid gas analysis. Mercury traps (Method 30B) were employed to measure mercury emissions and quantify capture performance. Production was not affected during the test.

Open cta in a new tab
Off
Background Grey
Off
One column
The benefits

The trial confirmed that the Sorbacal® Micro blend offers an effective solution to simultaneously control HCl and mercury emissions, with a single sorbent.

It allowed the customer to use their existing single DSI system, reducing the cost and time to implement controls while meeting both emission limits. Over 95% of HCl and more than 80% of mercury were abated with the Sorbacal® Micro blend, at relatively low feed rates. These reductions resulted in compliance with regulations.

Open cta in a new tab
Off
Background Grey
Off
PAC feed rate_FGT case study11.png
Figure 1: Hg reduction as a function of feed rate using: (1) separate PAC and trona injections at two locations (orange), (2) separate PAC and Sorbacal® SP injections at two locations (red), and (3) a single injection of blended Sorbacal® SP with 10% PAC (Sorbacal Micro® 2410 (green)
Mass ration_FGT case study 11.png
Figure 2: HCl abatement with Sorbacal® Micro 2410 (Sorbacal® SP and PAC blended sorbent) matched the performance of separate Sorbacal® SP and PAC injections. Hg capture with trona and PAC was less effective than with Sorbacal® SP and PAC, possibly due to NO₂ emissions from trona negatively impacting PAC performance.
Sorbacal® Micro enables U.S. industrial boilers to meet NESHAP limits by combining HCl and mercury control
Route category